B
SDV — Switched Digital Video Controls • RTSP Controller Configuration
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
164
573408-001-a
RTSP Controller Configuration window field definitions
Item Definition
Manager IP Address
IP address of the session manager.
Manager Port
Area reserved for entering the Manager Port number (RTSP SDV mode only).
Range: 0 – 65535
The default value is 7100.
Hold Time (s)
This is the amount of time (in seconds) that the APEX1000 will wait for a
keepalive message. If the timer expires, the connection to the manager is
considered lost.
The ERM and APEX1000 are both configured with a Hold Time. The lower of
these two Hold Times is used, so the actual Hold Time may differ from what
is configured on the APEX1000.
Valid range: 0, 9 – 300 s
The default value is 30 s.
MHA Manager Port
Area reserved for entering the MHA Manager Port number. (MHA mode
only)
Valid range: 1024 – 65535
The Default value is 6069.
Address Domain
Area reserved for entering the domain of the EQAM. The address domain
must match between the APEX and the ERM. A value of 0 means the APEX
will communicate with an ERM in any address domain.
Range: 0 – 255
The default value is 0.
MHA UDP Map
Establishes whether the UDP map attribute reports all 0s (disabled), or the
UDP ports associated with the QAM channel per the UDP port map
algorithm (enabled).
Range: Enabled, Disabled
The default value is Disabled.
Streaming Zone
This is a user-configured parameter, up to 128 characters.
This field generates the MPEG transport names, which are reported to the
controller and shown in the RTSP QAM Configuration window – streaming
zone. TSID (TSID – Transport Stream ID #).
Note: This field must match the value(s) configured in the controller.
APEX Device Name
Area reserved for entering the Device Name.
Controller Discovery
Shows status of the APEX1000’s knowledge of the Controller.
Values are:
• Discovered – Indicates that the Controller is known.
• Connection Lost – Indicates that communication with the Controller was
lost.
To Next Page
Loading...
Need help?
General
