SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
TRANSMISSION
Ch 2 page 178 Ch 2 page 179
TRANSMISSION
TRANSMISSION
Ch 2 page 178 Ch 2 page 179
TRANSMISSION
Figure 193
Figure 196
Figure 195
Figure 194
Remove adjusting ring.
Pre-load compression spring by means of special device (S).
Squeeze out snap ring and remove the released components.
Accordingly disassemble opposite components (K3-side).
(S) Pressure piece 504211
Squeeze out snap ring.
Disassemble end shim and plate pack K4.
Pull off tapered roller bearing.
(S) 3-leg puller 504236
To Next Page
Loading...