SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
TRANSMISSION
Ch 2 page 258 Ch 2 page 259
TRANSMISSION
TRANSMISSION
Ch 2 page 258 Ch 2 page 259
TRANSMISSION
Figure 468
Figure 470
Figure 469
Determine measure I, see figure on the left!
Measure I e.g. ....................................... 32,90 mm
(S) Digital depth gauge 504175
Line up shim(s) e.g.. s = 2,6 mm (arrow) and mount socket
head screw.
Wet thread of the socket head screw with
Loctite (type-no. 243)!
Torque limit (M10/8.8) ................. M
A
= 46 Nm
CALCULATION EXAMPLE “ I “:
Measure II e.g. ......................................... 34,50 mm
Measure I e.g. ......................................
− 32,90 mm
Difference .............................................. = 1,60 mm
Adjusting measure ................................. + 1,00 mm
Gives him(s) s = 2,60 mm
Adjusting measure = 1,0 mm, gives the
required shifting travel!
Mount flat gasket and determine measure II from mounting
face to bore root (stop face/socket head screw).
Measure II e.g.. ......................................... 34,50 mm
To Next Page
Loading...