3-49
3.3 Memory Switch Adjustment
3.3.1 Setting the Memory Switches
These switches are used to program internal machine parameters. The primary back up battery
maintains these settings if power are lost.
1. From standby, press <Setting>, <*>, <0>, <1>.
2. Press [Mem Switch Edit].
3. Call up the desired switch by pressing [ ] or [ ], or by pressing the numeric keypad.
4. Select the desired switch by pressing the box.
5. To navigate through the memory switch settings:
• The bits are ranged from 7 (left) to 0 (right).
• Press[ ]or[ ]of the cursor key to move the cursor.
• Press <0> or <1> on the numeric keypad, or[ ] or[ ], to change the bit value.
• Press <Enter> to save the setting of the displayed memory switch and return to the memory
switch edit screen.
• Press <Reset> not to save the setting of the displayed memory switch.
6. If you want to set other memory switches, repeat step 3-5. Otherwise, proceed to step 7.
7. Press <Reset> to return the machine to standby.
Note: You can confirm the initial setting of each Memory Switch by the Memory Switches List.
The memory switch List will be printed by pressing <Setting>, <*>, <1>, <0>.
To Next Page
Loading...
Need help?
General
