3-160
3.29 Quick Initial settings
At installation, you should set some parameters according to the following procedures.
You can do the following setting continuously by using this mode.
1. Initial settings
2. Consumable order sheet settings
3. Service Report settings
Note: Before starting the installation settings, clear the memory by pressing <Setting>, <*>, <0>, <2>,
[Enter].
Initial setup
1-1. To start Initial setting mode, press <Setting>, <*>, <9>, <9>. The LCD shows:
1-2. Enter the items following the LCD.
See “Initial setup” in the MFP User’s Guide for detailed instructions.
1-3. After you have entered all the items, press [Enter].
Consumable order sheet settings
2-1. The LCD now shows the consumable order sheet setting menu.
2-2. Set, clear or print the consumable order sheet. See “3.16 Consumable order sheet” on page
3-126 for detailed instructions.
2-3. After you have entered all the items, press [Enter].
To Next Page
Loading...
Need help?
General
