Muratec F-525 - Machine Parameter Adjustment

3-3
3.2 Machine Parameter Adjustment
3.2.1 Setting the Machine Parameters
These switches are used to program internal machine parameters. The primary back up battery
maintains these settings if power is lost.
1. From standby, press <Setting>, <*>, <0>, <0>.
2. Press [Edit Parameters].
3. Call up the desired switch by pressing[ ] or[ ], or by pressing the numeric keypad.
4. Select the desired parameter by pressing the box.
5. To navigate through the machine parameter settings:
•
The bits are ranged from 7 (left) to 0 (right).
• Press [
]
or[
]
of the cursor key to move the cursor.
• Press [0] or [1] on the numeric keypad, or[ ] or[ ], to change the bit value.
• Press [Enter] to save the setting of the displayed parameter and return to the machine pa-
rameter edit screen.
•
Press [Back] not to save the setting of the displayed parameter.
6. If you want to set other machine parameters, repeat step 3-5. Otherwise, proceed to step 7.
7. Press <Reset> to return the machine to standby.
Note: You can confirm the initial setting of each Machine parameter by the Machine Parameters List.
The Machine Parameters List will be printed by pressing <Setting>, <*>, <1>, <0>.