4-14
4.10 Error Codes
If an error occurs during a communication, a check message will be printed. The following provides an
explanation of the information found on check messages.
•
A possible solution to the problem
•
The date and time of the attempted communication
•
The sending location (if the remote fax has a Location ID)
•
The number of pages which got through before the error terminated the call
•
The error code
•
The sample document.
You will also see a code listed in the Result column of the report. Result codes indicate the specific problem
encountered:
•
“D” codes occur while dialing
•
“R” codes occur during reception
•
“T” codes occur during transmission
Here is a list of error codes the fax machine may print.
4.10.1 Dialing errors
D.0.2 The remote unit is busy. Try the call again.
D.0.3, The remote unit didn’t respond, the call couldn’t be completed or stop was pressed during
D.0.8 dialing. Retry the call. If your machine repeats the message, call the remote fax unit’s operator
and verify that unit is operating properly.
D.0.6, Either the remote unit didn’t respond, the call somehow didn’t go through or <Stop> was
D.0.7 pressed during dialing. Try the call again.
To Next Page
Loading...
Need help?
General
