Muratec F-525 - Updating the Software Using the Pc

3-170
3.31.3 Updating the software using the PC
Important: You cannot update the software in following situations:
· The machine is in transmission
· The machine is in scanning or in printing
· Data are stored in memory
In that case, wait until the transmission, scanning or printing ends, or the stored data is transmitted, deleted
or whatever and update the software.
1. Press <Setting>, <*>, <9>, <8>, [Enter].
2. Press [Main Board].
3. Connect your PC and the machine with USB cable.
4. Click [Start] on the PC screen.