3-73
3.4 Setting Individual Autodialer Attributes
This function allows the user to configure an individual address book entry with the settings shown in
Memory Switches 010, 011, 012 and 013.
To set the individual attributes:
1. Change memory switch 15, bit 7 to “1”. (See setting 3.3.1 Setting the Memory Switches for more
information on changing memory switch 015.)
2. When the function is enabled, an “Attribute” option is added to the address book destination reg-
istration steps. As an address book destination is programmed, an extra step showing Attribute 1,
Attribute 2, Attribute 3, and Attribute 4 are added as the last step.
3.
Set the individual bit positions as shown in the following table. To change a setting, press[ ]or[ ]until
the cursor is below the desired bit position; then press <1> or <0> to make the change.
4. Press <Enter> to save the setting of the displayed attribute and advance to the next attribute.
5. To set the other attribute, repeat steps 3-4.
6. When the last attribute is set, the fax will advance to the next autodialer programming steps.
To Next Page
Loading...
Need help?
General
