4-8
4.9 LCD Error Messages
Your fax machine’s LCD messages can help you spot problems.
LCD error messages (Alphabetic list)
Message on the display Description / Solution
[Sort] must be turned On when
making a duplex copy.
You tried to set [Sort] to [OFF] while Duplex Copy. Duplex Copy
should be combined with sort.
Add/Edit cannot be performed. You cannot add/enter destinations to the Address Book while
selecting other destinations.
ADF is unavailable
Set the document on the FBS glass
You tried to make a Card Copy using the ADF. Use the document
glass.
Already stored You tried to select a number that has already been selected. Enter
a different number.
An attachment cannot be scanned to
the folder from which it was added.
You tried to scan to folder with files attached and save them to the
same folder where the attached files are originally saved.
An I.D.Code is needed You cannot set “0000” as an I.D. Code for Security box.
An LDAP server has not been
registered.Check the LDAP server
settings.
The advanced search failed due to an internal machine error.
Check the LDAP server setting again, and try the search again.
For more information about LDAP server set up, refer to the MFP
User’s Guide or PC User’s Guide.
An LDAP server has not been
selected.Check the LDAP server
settings.
An LDAP server must be registered LDAP server has not been set up. To use the advanced search,
set up the LADP server on your machine prior to searching. For
more information, refer to the MFP User’s Guide or PC User’s
Guide.
Auto ratio is set. Auto ratio is selected automatically.
To specify the zoom ratio, press [Zoom] and enter your desired
zoom ratio.
Box in use. You tried to erase an F-Code box which contains at least one
document. Erase the document(s), then try again.
Broadcast cannot be turned off. You tried to set Broadcast to [OFF] after multiple destinations have
been selected.
Calibrating Scanner The scanner is warming up now
Call Service :Code An internal error has occurred. See “4.11 Service Call Error” on
page 4-17 how to solve the problem.
Cannot change the setting for Rx
separator cassette.
The cassette/tray you selected is used for separator page. Select
other cassette/tray.
Cannot combine with Card copy Your selected function cannot be combined with card copy.
Cannot enter additional commands The stored commands are full. Wait until one or more jobs are
done.
Cannot find the domain DHCP configuration failed. Check the Network setting. For more
information, refer to the MFP User’s Guide or PC User’s Guide.
Cannot select mode during Fax&Copy You tried to switch the mode to others while Fax&Copy mode.
Changing mode in Fax&Copy is not available.
Cannot store in a secure box. You tried to store a document in an F-code Secure box. If you
need to store documents, use an F-code Bulletin box.
Cannot use the same code for both
Read/Write and Read Only.
You cannot use the same protect code for “Read/Write” and “Read
Only”. Enter a different one.
Check Paper Source The selected paper is not suitable for copying or printing. Select
other paper source.
Check the paper size.
Open & Close Front cover.
The loaded paper does not match the paper registered in the
machine. Set correct sized paper or change the paper size setting.
Open and close the front cover to reset the printer.
To Next Page
Loading...
Need help?
General
