NEC Univerge SV9100 - Page 101

Issue 2.0
4-22 Features and Specifications
GUIDE TO FEATURE PROGRAMMING
This guide provides a list of associated Programs that support this feature. .
Program
Number
Program Name/Description Input Data Default
10-12-01 GCD-CP10 Network Setup - IP Address
Should be set to 0.0.0.0 when using PRG 10-
12-09.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.254.255.254
192.0.0.1 ~ 223.255.255.254
Default =
192.168.0.10
10-12-03 GCD-CP10 Network Setup – Default
Gateway
Assign the default gateway IP address for the
GCD-CP10.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.254.255.254
192.0.0.1 ~ 223.255.255.254
Default = 0.0.0.0
10-12-09 GCD-CP10 Network Setup – IP Address
Set IP Address for GPZ-IPLE.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.254.255.254
192.0.0.1 ~ 223.255.255.254
Default =
172.16.0.10
10-19-01 VoIP DSP Resource Selection
Select type of GPZ-IPLE DSP Resource. This
program setting has no affect on the terminal/
trunk port assignment or usage.
0 = Common use for both IP
extensions and trunks
1 = IP Extension
2 = SIP Trunk
3 = CCIS
4 = Use for NetLink
5 = Blocked
Resource 1 = 1
Resource
2 ~ 256 = 0
10-50-01 License Information – License Name
Read Only program used to confirm license
information that is stored in a system.
N/A
10-54-01 License Configuration for Each Package –
License Code
Assign VoIP resource licenses (5103) to the
GCD-CP10 slot (1).
1 ~ 255 resource licenses No Setting
10-68-01 IP Trunk Availability – Trunk Type
Set trunk type to CCISoIP for interconnecting
trunks.
0 = None
1 = SIP
2 = H.323
3 = CCIS
Default = 0
10-68-02 IP Trunk Availability – Start Port
Set the trunk port number to start the
assignment from.
0 ~ 400 Default = 0
10-68-03 IP Trunk Availability – Number of Ports
Set the number of ports to assign from the
starting point set in 10-68-02.
0 ~ 400 Default = 0
11-01-01 System Numbering – Service Code
The Call reroute feature only supports closed
numbering.
This program is used to customize the system
internal (Intercom) numbering plan.
Refer to the
Programming
Manual for
default values.