Issue 2.0
SV9100 Networking Manual 6-7
changed to a video call.
A video caller cannot use CTI/OAI at the same time as the CTI/OAI
feature needs P2P to be set to off.
When the video interconnection using a SIP trunk is configured, other
SIP connections, such as a SIP carrier connection is not supported in
the same system.
Video capability in the initial invite message is required for the Video
Terminal.
When using an MCU, the SV9100 requires the Carrier Type Setting
(Program 10-29-14) to be set to 0 = Standard.
When using an MCU, the same video capability must be set between
the MCU and the Video SIP Terminal.
Default Settings
This feature is not enabled at default.
System Availability
Terminals
Polycom HDX4003
Polycom VVX1500D
Required Component(s)
GCD-CP10 with GPZ-IPLE installed.
Related Features
None
SECTION 5 GUIDE TO FEATURE PROGRAMMING
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned
when programming this feature in the order they are most commonly used. These
levels are used with PCPro and WebPro wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this
To Next Page
Loading...
