NEC Univerge SV9100 - Page 367

Issue 2.0
SV9100 Networking Manual 6-21
SIP Trunk E.164 Support
SIP Trunk E.164 CLIP Enhancement
Program
Number
Program Name/Description Input Data Default
Level
1 2 3
10-02-01 Location Setup – Country Code
Enter the country code.
Dial (maximum of four digits)
0 ~ 9,

, #
1

10-02-02 Location Setup – International Access
Codes
Enter the international access code.
Dial (maximum of four digits)
0 ~ 9,

, #
No Setting

44-01-02 System Options for ARS/F-Route – Dial
Tone Simulation
When first dialed, digit matches the data set in
this Program, system sends simulated DT to
calling party after receiving first digit.
Numbering plan for the dial needs to be
configured as F-Route in Program 11-01.
Dial (maximum of one digit)
0 ~ 9,

, # cannot be used
No Setting

44-01-03 System Options for ARS/F-Route – Tone
Type
Set simulated DT to type which can change the
tone used in Program 44-01-02 and Program
44-02-04.
0 = Internal Dial Tone
1 = External Dial Tone
0

84-14-13 SIP Trunk Basic Information Setup –
Incoming/ Outgoing SIP Trunk for E.164
When this data is set to 1, then for any
outbound SIP calls a
+ is added as a prefix to
the Request-URI, To and From header fields of
the SIP message.
When it is set to 2 then if the dialed international
access code matches the value in Program
10-02-02 this value is removed from the
number dialed and the
+ added as a prefix to
the Request-URI, To and From header fields of
the SIP Message.
0 = Off
1 = Mode 1
2 = Mode 2
3 = Mode 3
(Profile 1 ~ Profile 2)
0

Program
Number
Program Name/Description Input Data Default
Level
1 2 3
10-02-01 Location Setup – Country Code
Enter the country code.
Dial (maximum of four digits)
0 ~ 9,

, #
1

10-02-02 Location Setup – International Access
Codes
Enter the international access code.
Dial (maximum of four digits)
0 ~ 9,

, #
No Setting

10-02-03 Location Setup – Other Area Access Code
Enter the other area access code.
Dial (maximum of two digits)
0 ~ 9,

, #
9
