NEC Univerge SV9100 - Page 368

Issue 2.0
6-22 SIP Trunking
Video Support over SIP Trunks
84-14-13 SIP Trunk Basic Information Setup –
Incoming/ Outgoing SIP Trunk for E.164
When this data is set to 1, then for any
outbound SIP calls a
+ is added as a prefix to
the Request-URI, To and From header fields of
the SIP message.
When it is set to 2 then if the dialed international
access code matches the value in Program
10-02-02 this value is removed from the
number dialed and the
+ added as a prefix to
the Request-URI, To and From header fields of
the SIP Message.
0 = Off
1 = Mode 1
2 = Mode 2
3 = Mode 3
(Profile 1 ~ Profile 2)
0

84-14-16 SIP Trunk Basic Information Setup – SIP
Trunk SIP-URI E.164 Incoming Mode
When this data is set to 1, then for any inbound
SIP calls that include a
+ and a country code
not defined in Program 10-02-01, delete the
+
and add the International Access Code in
Program 10-02-02. If the country code is a
match then delete both the
+ and country code
but do not add the International Access code.
When it is set to 2, then for any inbound SIP
calls that include a
+ and a country code not
defined in Program 10-02-01, delete the
+ and
add the International Access Code in Program
10-02-02. If the country code is a match then
delete both the
+ and country code and add the
Caller ID Edit Code from Program 10-02-03.
0 = Disable
1 = Mode 1
2 = Mode 2
(Profile 1 ~ Profile 2)
0

Program
Number
Program Name/Description Input Data Default
Level
1 2 3
Program
Number
Program Name/Description
Input Data Default
Level
1 2 3
10-12-01 GCD-CP10 Network Setup – IP Address
It is recommended to set this program to
0.0.0.0. All connections to the system are made
through the IPLE.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
192.168.0.10

10-12-03 GCD-CP10 Network Setup – Default
Gateway
Assign the default gateway IP address for the
GCD-CP10.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.254.255.254
192.0.0.1 ~ 223.255.255.254
0.0.0.0

10-12-08 GCD-CP10 Network Setup – ICMP Redirect
When receiving ICMP redirect messages, this
determines if the IP Routing Table updates
automatically or not.
0= (Enable)
1= (Disable)
0
