NEC Univerge SV9100 - Page 477

Issue 2.0
9-10 IP Single Line Telephone (SIP)
10-33-02
SIP Registar/Proxy
Information Basic Setup
- Authentication Mode
When connecting a standard
SIP terminal via NAT, this
opion must be enabled to
prohibit illegal SIP phone
registration.
0 = Disable
1 = Enable
(default = 0)
X
10-33-05 SIP Registar/Proxy
Information Basic Setup
– NAT Mode
When system controls remote
SIP phone via NAT router, set
this program to 1 = Enable.
0 = Disable
1 = Enable
(default = 0)
X
10-37-01 UPnP Setup – UPnP
Mode
Enable/Disable UPnP. 0 = Disable
1 = Enable
(default = 0)
X
10-58-01 Network Address This program sets the IP or
Network address for phones
that are not to be routed
through the NAPT
translations.
For example, if a system had
multiple NAPT phones and
another site, with multiple IP
phones connected via a VPN
connection, you would not
want the phones connected
over the VPN to use the
NAPT feature. The network
address (or single IP phone
addresses) of the Remote
location would be entered
here. This is for the IP
Phones at this location to not
use the NAPT feature.
0.0.0.0~
126.255.255.254
128.0.0.1~
191.255.255.254
192.0.0.1~
223.255.255.254
(default = 0.0.0.0)
X
Program
Number
Program Name Description/Comments Assigned Data 1 2 3