NEC Univerge SV9100 - Page 589

Issue 2.0
11-16 NAPT
10-46-01 DT800/DT700 Server Information
Setup - Register Mode
Normal mode:
When the phone boots up, it
reports the ext. assigned in the
phone or chooses the next
available extension in the system.
No password is required.
Auto mode:
If set to Auto, the SIP user name
and password must be entered in
the actual IP phone. These
settings must match 84-22/
15-05-27, for the phone to come
on-line.
Manual mode:
When the phone boots up it
prompts a user to enter a user ID
and password before logging in. It
checks the user ID/password
against 84-22/15-05-27. If there is
no match, the phone does not
come on-line.
0 = Normal (default)
1 = Auto
2 = Manual

10-46-06 Register Port
Assign the port number to which
the SIP messages are sent to on
the IPLE. This same port number
must be assigned in the SIP
Multiline terminals. If this command
is changed, it requires a CPU
reset.
0~65535 5080

10-46-13 Subscribe Session Port 0~65535 5081

10-46-14 NAT Mode Turns On/Off the NAT mode of the
system.
0 = Off
1 = On
Default = Off

10-58-01 Network Address This program sets the local area
network of the DT800/DT700
terminal when the system has a
NAT router and a local router.
0.0.0.0 ~
126.255.255.254
128.0.0.1 ~
191.255.255.254
192.0.0.1 ~
223.255.255.254

Program
Number
Program Name Description/Comments Assigned Data
Level
1 2 3