NEC Univerge SV9100 - Page 660

Issue 2.0
SV9100 Networking Manual 13-65
10
Master/Slave System
If set to 0, system is synchronized to
network clock. If set to 1, system is not
synchronized to the network clock.
0 =Slave System
1 =Master System
0
11
Networking System No.
0 - 50
0
14
Service Protocol for S-point
0 =Keypad facility
1 =Specified Protocol for Aspire
system
0
15
Call Busy Mode for S-point
0=Alerting
1 =Disconnect
0
17
ISDN Line Ringback Tone
If Telco does not provide ringback tone,
SV9100 can if set to 1:Enable.
0 =Disable
1 =Enable
0
18
Type of Number
ISDN Protocol definition
0 =Unknown
1 =International number
2 =National number
3 =Network specific number
4 =Subscriber number
5 =Abbreviated number
0
19
Numbering Plan Identification
ISDN Protocol definition
0 =Unknown
1 =ISDN numbering plan
2 =Data numbering plan
3 =Telex numbering plan
4 =National standard numbering
plan
5 =Private numbering plan
0
22
QSIG Operation Mode
0 =Disable
1 =Enable
0
23
Straight/Cross Wiring
0=Auto
1 =Manual (Cross)
2 =Manual (Straight)
0
24
Power feeding for S-point
0 =Disable
1 =Enable
0
Item
No
Item Input Data Default