LAN Configuration
112
NETGEAR ProSAFE VPN Firewall FVS318G v2
2. Select Network Configuration > Routing.
3. Click the Add
table button.
4. Enter the settings as described in the following table:
Table 24. Add Static Route screen settings for IPv4
Setting Description
Route Name The route name for the static route (for purposes of identification and
management).
Active To make the static route effective, select the Active check box.
Note: A route can be added to the table and made inactive if not needed. This
allows you to use routes as needed without deleting and re-adding the entries. An
inactive route is not advertised if RIP is enabled.
Private If you want to limit access to the LAN only, select the Private check box. Doing so
prevents the static route from being advertised in RIP.
Destination IP Address The destination IP address of the host or network to which the route leads.
Subnet Mask The IP subnet mask of the host or network to which the route leads. If the
destination is a single host, enter 255.255.255.255.
Interface Select the physical or virtual network interface (WAN, VLAN, or DMZ interface)
through which the route is accessible.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
