NETGEAR ProSAFE SRX5308 - Page 241

VPN Mode Configuration Commands
241
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
vpn sslvpn users users edit <row id>
This command configures an existing user account. The command is not limited to SSL VPN
users. After you have issued the vpn sslvpn users users edit command to specify
the row to be edited, you enter the vpn-config [users] mode, and then you can configure one
keyword and associated parameter or associated keyword at a time in the order that you
prefer. You cannot change the name of the user or the group to which the user is assigned.
The changes you can make to the user type are restricted.
Related show command: show vpn sslvpn users users
vpn sslvpn users users delete <row id>
This command deletes a user account by specifying its row ID.
Step 1 Format vpn sslvpn users users edit <row id>
Mode vpn
Step 2 Format user_type {SSLVPNUser | Administrator | Guest | IPSECVPNUser |
L2TPUser | PPTPUser}
password <password>
confirm_password <password>
idle_timeout <minutes>
Mode vpn-config [users]
Keyword Associated Keyword to Select
or Parameter to Type
Description
user_type SSLVPNUser, Administrator,
Guest, IPSECVPNUser,
L2TPUser, or PPTPUser
Specifies the user type.
Note: You cannot change an existing user from the
L2TPUser or PPTPUser user type to another type or
from another type to the L2TPUser or PPTPUser
type.
password password The password (alphanumeric string) that is assigned
to the user. You need to issue the
confirm_password keyword and confirm the
password.
confirm_password password The confirmation of the password.
idle_timeout minutes The idle time-out in minutes.
Format vpn sslvpn users users delete <row id>
Mode vpn