3-50
Chapter 3 SETTINGS FOR FUNCTIONS
ZW
User’s Manual
Chapter 3
Setting the System
Initializing Settings
Returns all banks/system settings to their default settings.
• The settings of all banks/system settings are returned to the default settings regardless of the currently
selected bank number.
• Parameters for which the default values are decided by the Sensor Head measuring range (Hys,
Trigger hys, HIGH Threshold, LOW Threshold) are all set to the default value of "0", which is the
factory default.
Here is an explanation of the procedure for restoring the default settings.
Operating procedure
Steps
Key operation Display Description
1 Press key for two seconds to enter the FUN
mode.
2 Press or keys to select either of "SYSTEM"
and press key.
3 Press or keys to select either of "INIT" and
press key.
4 "OK/CAN" is displayed on the sub-display.
Press key to return the settings to their default
settings or key to cancel.
5 Press key for two seconds to enter the RUN
mode.
RUN
FUN
TEACH
ZERORST/ZERORST/
ESCESC
ZERO/ZERO/
SETSET
ZERORST/ZERORST/
ESCESC
ZERO/ZERO/
SETSET
ZERO/
SET
ZERORST/
ESC
RUN
FUN
TEACH
To Next Page
Loading...
Need help?
General
