Omron ZW Series User Manual

6-10
Chapter 6 SPECIFICATIONS AND EXTERNAL DIMENSIONS
ZW
User’s Manual
Chapter 6
Controller
Status Indicators for Controller
Note: Do not obtain data during start-up. The RS-232C output is indeterminate at this time.
Measure-
ment
mode
Status
Display Output Input
RS-232C/
Ethernet
11 segment
display
Analog
output
Judgment
output
(HIGH/
PASS/
LOW)
Binary
output
LED OFF Zero reset
RUN Normal
measurement
Measure-
ment result
Output
accord-
ing to the
mea-
sure-
ment
result
Judg-
ment
result
Output
according
to the
mode
(Measure-
ment
result/
Judgment
result)
Enabled Enabled Enabled
Mea-
sure-
ment
error
Keep Previous
value
Clamp “------” Output at
clamp
level
Output
OFF
Output of
the mea-
sured
value:
clamp
level
Judgment
output:
Output
OFF
Disabled
Measured value
not determined
-
LED OFF -
FUN - Display
according
to the
menu
Disabled
System
error
-
“SYS.ERR”
blinking
Voltage:
Output of
0 V
Current:
Output of
12 mA
Disabled Enabled
A com-
mand is
received
but is not
exe-
cuted.
When
starting
- “INIT” Output at
clamp
level
(approx.
-10.8 V)
Output
OFF
Disabled
(Note)

Omron ZW Series Specifications

General

Brand	Omron
Model	ZW Series
Category	Accessories
Language	English