Omron ZW Series User Manual

7-8
Chapter 7 APPENDIX
ZW
User’s Manual
Chapter 7
Updating Firmware
Updating Firmware
This section describes how to update the firmware of ZW Series Controllers.
Use Warp Engine ZW to update the firmware.
Warp Engine ZW is automatically installed when Smart Monitor ZW is installed.
The most recent version of the software can be downloaded from the following website for
OMRON members. Refer to the Member Registration Sheet that is enclosed with the
Controller.
http://www.omron-cxone.com/zw
• While updating, do not turn off the power of the controller. The controller will not start normally.
• To install, log on as an Administrator or a user with system access rights.
Flow of Updating Firmware
Refer to “Troubleshooting” -
“Communication error” (p.7-4)
Connecting Controller to
a personal computer
Normal?
Starting Warp Engine ZW
Setting the firmware information
Performing update of firmware
Normal end
Please contact an OMRON
sales representative.
Installing Smart Monitor ZW
Error?

Omron ZW Series Specifications

General

Brand	Omron
Model	ZW Series
Category	Accessories
Language	English