Chapter 3 SETTINGS FOR FUNCTIONS
Chapter 3
Setting the Output Conditions
3-21
ZW
User’s Manual
Setting the Scaling
This setting is used when you want to correct any errors that are generated due to the
installation status of the Sensor Head,
and display the corrected value on the main display as a measured value.
There are three types of setting: "auto scaling" ("one-point scaling" and "two-point
scaling") that automatically sets the correction value of a placed sensing object, "manual
scaling" that manually sets the correction value and "thickness scaling" that sets the
sensing object (transparent object) and automatically sets the correction value.
The "zero Reset" (p.3-37) settings return to the default settings when scaling is set. If scaling is set,
perform a zero reset as necessary.
● One-point scaling
A measurement is performed at one position and offset values are set for that
measured value.
The offset and increment/decrement inversion can be set. (Default value: OFF)
Example: When displaying the distance to the sensing object
4.5
4.5
Sensor head
Measured value:
4.5 mm
0 mm
Measuring center
distance
Sensing
object
Target display value:
Relative reference value
from the sensor with this
distance as the reference.
Default
display
Display value
(mm)
Measured value
(mm)
To Next Page
Loading...
Need help?
General
