Omron ZW Series User Manual

Chapter 4 I/O SETTINGS
Chapter 4
Timing Charts
4-37
ZW
User’s Manual
(Caution)
When the setting for non-measurement is "Clamp", if the sampling value is an abnormal value or an
undetermined value *, sampling is not executed. If sampling has been started, it is stopped. The output
value is as follows.
- The clamp value is held.
- If the previous hold value is not the clamp value, the GATE signal is output.
- The BUSY signal is turned OFF.
To start and continue sampling even if a sampling value is an abnormal value or an undetermined value,
set "Keep" as the non-measurement setting.
* After the start of measurement, if measurement results are not obtained the number of times required to
take the average, the measurement result is not applied.

Omron ZW Series Specifications

General

Brand	Omron
Model	ZW Series
Category	Accessories
Language	English