Omron ZW Series - Page 198

5-22
Chapter 5 Ethernet/RS-232C COMMUNICATION
ZW
User’s Manual
Chapter 5
Connecting Using RS-232C Cable
■ Zero reset execution command <ZC command>
Cancel the zero reset of the specified task.
<Command format>
<Response format>
• Normal processing
- If the task number is omitted, the zero reset is cancelled for the task of which the result is cur-
rently displayed.
- If "4" is set for the task number, the zero reset is cancelled for all tasks.
• When a command was not successfully processed
<Parameter explanation>
Parameter Details
Task number Specifies the number of the task for which the zero reset is to be cancelled.
0: TASK1
1: TASK2
2: TASK3
3: TASK4
4: TASK1 to 4
CRCZ
㸡
Task number
㸡
Space
OK CR
ERCR