Verify NVMe Cable Connections
This step halts the system so NVMe cable connection tests can be run for the NVMe storage
drives.
3.
Open a terminal window. Using SSH (secure shell), log in to the Oracle ILOM
command-line interface (CLI) on the server SP.
4.
To access the Oracle ILOM Diagnostic Shell, type the start /sp/diag/shell
command, and then click Enter.
5.
Type y to confirm that you want to start the Oracle ILOM Diagnostic Shell.
The diag> prompt appears.
6.
To run the NVMe cable connection tests, type the hwdiag io nvme_test command,
and then click Enter.
Your output should be similar to the following example:
diag> hwdiag io nvme_test
HWdiag (Diag Shell) - Build Number 120817 (Aug 21 2017, 00:15:43)
Current Date/Time: Oct 04 2017, 17:19:34
Checking NVME drive fru contents...
checking fru on drive NVMe 0 OK
checking fru on drive NVMe 1 OK
checking fru on drive NVMe 2 OK
checking fru on drive NVMe 3 OK
checking fru on drive NVMe 4 OK
checking fru on drive NVMe 5 OK
checking fru on drive NVMe 6 OK
checking fru on drive NVMe 7 OK
checking fru on drive NVMe 8 OK
checking fru on drive NVMe 9 OK
checking fru on drive NVMe 10 OK
checking fru on drive NVMe 11 OK
NVME drives fru check: PASSED
Checking NVME drive pcie links...
checking pcie link on drive NVMe 0 OK
checking pcie link on drive NVMe 1 OK
checking pcie link on drive NVMe 2 OK
checking pcie link on drive NVMe 3 OK
checking pcie link on drive NVMe 4 OK
checking pcie link on drive NVMe 5 OK
checking pcie link on drive NVMe 6 OK
checking pcie link on drive NVMe 7 OK
checking pcie link on drive NVMe 8 OK
checking pcie link on drive NVMe 9 OK
checking pcie link on drive NVMe 10 OK
Servicing NVMe Cables (FRU) 201
To Next Page
Loading...
Need help?
General
