Troubleshoot Hardware Faults Using the Oracle ILOM Web Interface
Related Information
■
“Troubleshoot Hardware Faults Using the Oracle ILOM Web Interface” on page 27
Troubleshoot Hardware Faults Using the Oracle ILOM Web
Interface
Note - The screens shown in this procedure might differ from those for your server.
This procedure uses the basic troubleshooting steps described in “Basic Troubleshooting
Process” on page 26.
Use this procedure to troubleshoot hardware faults using the Oracle ILOM web interface and, if
necessary, prepare the server for service.
Note - This procedure provides one basic approach to troubleshooting hardware faults. It uses
the Oracle ILOM web interface. However, the procedure can be performed using the Oracle
ILOM command-line interface (CLI). For more information about the Oracle ILOM web
interface and CLI, refer to the Oracle ILOM documentation.
1.
Log in to the server SP Oracle ILOM web interface.
Open a browser and direct it using the IP address of the server SP. Enter a user name (with
administrator privileges) and password at the Login screen. The Summary Information page
appears.
The Status section of the Summary Information page provides information about the server
subsystems, including:
■
Processors
■
Memory
■
Power
■
Cooling
■
Storage
■
Networking
2.
In the Status section of the Oracle ILOM Summary Information page, identify the
server subsystem that requires service.
Troubleshooting and Diagnostics 27
To Next Page
Loading...
Need help?
General
