Assign Serial Port Output Using the Oracle ILOM CLI
You can assign serial port output using either the Oracle ILOM CLI interface or web interface,
as described in the following sections:
■
“Assign Serial Port Output Using the Oracle ILOM CLI” on page 43
■
“Assign Serial Port Output Using the Oracle ILOM Web Interface” on page 43
Assign Serial Port Output Using the Oracle ILOM CLI
1.
Open an SSH session, and at the command line, log in to the SP Oracle ILOM
CLI.
Log in as a user with root or administrator privileges. For example:
ssh root@ipaddress
Where ipaddress is the IP address of the server SP.
For more information, see “Accessing Oracle ILOM” in the Oracle X8 Series Servers
Administration Guide.
The Oracle ILOM CLI prompt (->) appears.
2.
To set the serial port owner, type:
-> set System/SP/serial/portsharing owner=host
Note - The serial port sharing value, by default, is owner=SP.
3.
Connect a serial host to the server.
Assign Serial Port Output Using the Oracle ILOM Web
Interface
1.
Log in to the SP Oracle ILOM web interface.
Open a web browser and direct it using the IP address of the server SP. Log in as root or a user
with administrator privileges. See “Accessing Oracle ILOM” in the Oracle X8 Series Servers
Administration Guide.
The Summary Information page appears.
2.
In the Oracle ILOM web interface, select ILOM Administration → Connectivity
from the navigation menu on the left side of the screen.
3.
Select the Serial Port tab.
Troubleshooting and Diagnostics 43
To Next Page
Loading...
Need help?
General
