23.3.4 UM Configuration—[4-3] Service Settings—Custom
Service—Day Control
The below parameters are set for the Menu Transfer Custom Service in the Custom Service Builder.
This
service allows you to assign a different operation for each day of the week, and for all holidays. The caller
makes no selection and no menu is announced.
Description
The information typed in this field is for reference only.
Default
Not stored
Value Range
Max. 32 characters
Maintenance Console Location
23.3.4 UM Configuration
—[4-3] Service Settings—Custom Service—Day Control
Feature Manual References
20.1.27 Unified Messaging—Custom Service
Sunday–Saturday, Holiday
Specifies a service for each day of the week and for all holidays.
Note
If an operation is assigned to "Holiday
" here, either one of the following settings is required in order to
activate the operation for the "Holiday" Custom Service:
a. In the Holiday Table, select "Custom Service Menu" and specify the number of this Date
Control—"Holiday" Custom Service, or the number of its higher layered Custom Service (see 23.4 UM
Configuration—[4-4] Service Settings—Holiday Table).
b. Assign the desired Date Control—"Holiday" Custom Service or its higher layered Custom Service to
the desired Port/CO line (see 22.1 UM Configuration—[3-1] UM Extension / Trunk Service—Service
Group).
For "Port Affected/Trunk Affected", exclude the Port/CO line numbers that are assigned to the Date
Control—"Holiday" Custom Service or the number of its higher layered Custom Service.
Default
Holiday: None
Value Range
Assigned Operation: Trf to Mbx, Trf to Ext, Operator, Trf to Out, Exit, Prev Menu, Cust Serv, VM Serv, Call Trf
Serv, Subscr Serv, Dial by Name, Repeat Menu, Main Menu, Trf to Fax Extn, List All Names, Fax Service,
None (see 23.3.1 UM Configuration—[4-3] Service Settings—Custom Service—Menu & Transfer—
Key – Assigned Operation: 0–9, *, #)
Document Version 2016-03 PC Programming Manual 1029
23.3.4 UM Configuration—[4-3] Service Settings—Custom Service—Day Control
To Next Page
Loading...
