Panasonic KX-NS1000 - PBX Configuration-[10-1] CO & Incoming Call-CO Line Settings

18.1 PBX Configuration—[10-1] CO & Incoming
Call—CO Line Settings
CO lines can be assigned a name, and grouped into a maximum of 256 trunk groups.
The Site, Shelf, Slot, and Port for each item are displayed for your reference. For details, see Common
Programming Reference Items in 9.1 PBX Configuration
—[1-1] Configuration—Slot.
Card Type
Indicates the type of card to which the CO line is connected
(reference only).
Default
Current card type
Value Range
Card type
Maintenance Console Location
18.1 PBX Configuration—[10-1] CO & Incoming Call—CO Line Settings
CO Name
Specifies
the CO line name which is shown on the extension’s display when receiving a call from the CO line.
Default
Not stored
Value Range
Max. 20 characters
Maintenance Console Location
18.1 PBX Configuration—[10-1] CO & Incoming Call—CO Line Settings
Feature Manual References
5.1.11 Display Information
Trunk Group Number
Specifies the trunk group number to which the CO line belongs.
When a V-IPGW card is installed, the value is automatically set to
"7" for the corresponding CO lines.
Default
1
Value Range
1–96
882 PC Programming Manual Document Version 2016-03
18.1 PBX Configuration—[10-1] CO & Incoming Call—CO Line Settings