9.14 PBX Configuration—[1-1]
Configuration—Slot
—V-IPEXT32—Card Property
The properties of the V-IPEXT card can be specified.
Signaling (PTAP) UDP Port No. (Server)
Specifies the UDP port used by the V-IPEXT card to transmit and receive PTAP (Panasonic Telephony
Administration Protocol) data. This must be changed if another network application is using the same port.
To change the value displayed here, click Common Settings and set the desired value.
Default
9300
Value Range
1024–65535
Maintenance Console Location
9.14 PBX Configuration
—[1-1] Configuration—Slot—V-IPEXT32—Card Property
Feature Manual References
10.1.17 IP-PT (IP Proprietary Telephone)
Signaling (MGCP) UDP Port No. (Server)
Specifies the UDP port used by the V-IPEXT card to transmit and receive MGCP (Media Gateway Control
Protocol) data. This must be changed if another network application is using the same port.
To change the value displayed here, click Common Settings and set the desired value.
Default
2727
Value Range
1024–65535
Maintenance Console Location
9.14 PBX Configuration
—[1-1] Configuration—Slot—V-IPEXT32—Card Property
Feature Manual References
10.1.17 IP-PT (IP Proprietary Telephone)
Signaling (MGCP) UDP Port No. (IP-PT)
Indicates the UDP port used to transmit and receive MGCP
(Media Gateway Control Protocol) data on the
IP-PT side (reference only).
Document Version 2016-03 PC Programming Manual 355
9.14 PBX Configuration—[1-1] Configuration—Slot—V-IPEXT32—Card Property
To Next Page
Loading...
