Default
2427
Value Range
2427
Maintenance Console Location
9.14 PBX Configuration
—[1-1] Configuration—Slot—V-IPEXT32—Card Property
Feature Manual References
10.1.17 IP-PT (IP Proprietary Telephone)
Keep Alive Time-Out
Specifies the length of time that the PBX will continue to consider an IP
-PT to be active even if it receives no
transmissions from that IP-PT. The PBX constantly confirms the status of IP-PTs. If no communications are
received from an IP-PT for the duration specified here, the PBX considers the IP-PT to be unreachable, and
sets the port status to Fault.
During operation, set between 10 s and 60 s. Settings over 60 s, and Disable, are used for debugging purposes,
and IP-PTs cannot be guaranteed to function normally in these circumstances. Do not use debugging settings
unless instructed to do so.
To change the value displayed here, click Common Settings and set the desired value.
Default
20 s
Value Range
Disable, 10–120 s
Maintenance Console Location
9.14 PBX Configuration—[1-1] Configuration—Slot—V-IPEXT32—Card Property
Feature Manual References
10.1.17 IP-PT (IP Proprietary Telephone)
First Resending Time (PTAP)
Specifies the length of time that the PBX waits before starting to resend PTAP (Panasonic Telephony
Administration Protocol) data.
To change the value displayed here, click Common Settings and set the desired value.
Default
500 ms
Value Range
500 ´ n (n=1–16) ms
356 PC Programming Manual Document Version 2016-03
9.14 PBX Configuration—[1-1] Configuration—Slot—V-IPEXT32—Card Property
To Next Page
Loading...
