Panasonic KX-NS1000 - PBX Configuration-[3-12] Group-VM(DTMF) Group; PBX Configuration-[3-12-1] Group-VM(DTMF) Group-System Settings

11.12 PBX Configuration—[3-12] Group—VM(DTMF)
Group
11.12.1 PBX Configuration—[3-12-1] Group—VM(DTMF)
Group—System Settings
A Panasonic Voice Processing System
(VPS) with DTMF Integration can be connected to SLT ports of
KX-TDE/KX-NCP/KX-TDA PBXs. The SLT ports that are connected to the VPS are called a VM (DTMF) Group.
Settings for these groups can be programmed.
Notice
This screen is for programming legacy gateway PBXs. For information about setting up a legacy gateway
PBX, see 9.28 PBX Configuration—[1-1] Configuration—Slot—Legacy-GW1/Legacy-GW2.
Unless noted otherwise, the programming information is the same as described in the PC Programming
Manual of the legacy gateway PBX. Refer to the corresponding Group—VM(DTMF) Group—System
Settings section in the PC Programming Manual of the legacy gateway PBX for more information.
Document Version 2016-03 PC Programming Manual 699
11.12.1 PBX Configuration—[3-12-1] Group—VM(DTMF) Group—System Settings