7.4 Utility—Monitor/Trace
7.4.1 Utility—Monitor/Trace—ISDN/QSIG Protocol Trace
This utility collects protocol trace data from the PRI card, and displays it on the PC.
This option is only available at Installer level in On
-line mode, and requires that the target PRI card be set to
INS status.
Protocol trace data is continually accumulated on ISDN cards, and 3 types of data can be downloaded:
• Real Time Trace: Pseudo-real-time data is collected through data polling at one-second intervals. The
displayed information is updated beginning when the Start button is clicked.
• Accumulation Trace: Previously accumulated data is retrieved and displayed.
• Error Accumulation Trace: Previously accumulated error data is retrieved and displayed. This trace
shows the data snapshot that is taken just before a card resets.
To view trace data
1. From the Site-Shelf-Slot No. drop-down list, select the target slot. Each card will be preceded by the
pattern "X-Y-Z" as follows:
• X: Site number (1–16)
• Y: Shelf number (1–3)
– 1: KX-NS1000 physical shelf
– 2: Legacy Gateway 1
– 3: Legacy Gateway 2
• Z: Slot number (1–11)
2. From the Trace Data Type drop-down list, select the type of data to view.
3. Click Start.
Trace information will be displayed.
4. Select an option:
• Click Capture to save the displayed trace information.
• Click Clear to clear the screen display.
5. Click Cancel to return to the main screen.
130 PC Programming Manual Document Version 2016-03
7.4.1 Utility—Monitor/Trace—ISDN/QSIG Protocol Trace
To Next Page
Loading...
