Panasonic KX-NS1000 - PBX Configuration-[2-10] System-Extension CID Settings

10.10 PBX Configuration—[2-10]
System—Extension CID Settings
Various settings for extension Caller ID can be programmed.
Extension Caller ID Modulation Type
Specifies the modulation frequency to be used when sending Caller ID information to an SLT.
Default
Bell202(Bellcore)
Value Range
V.23(ETSI), Bell202(Bellcore)
Maintenance Console Location
10.10 PBX Configuration
—[2-10] System—Extension CID Settings
Feature Manual References
4.1.3 Caller ID
Channel Seizure Signal Bits
Specifies the number of seizure bits to send when sending Caller ID information to an SLT.
Default
300
Value Range
10 ´ n (n=3–40) bits
Maintenance Console Location
10.10 PBX Configuration
—[2-10] System—Extension CID Settings
Feature Manual References
4.1.3 Caller ID
Mark Signal Bits
Specifies the number of mark bits to send when sending Caller ID information to an SLT.
Default
180
Value Range
10 ´ n (n=3–40) bits
614 PC Programming Manual Document Version 2016-03
10.10 PBX Configuration—[2-10] System—Extension CID Settings