5.5 System Control—System Shutdown
In order to turn off the power to a PBX, it must first be issued a shutdown command using Web Maintenance
Console. Follow the procedure below to prepare a PBX for system shutdown.
When
the system is shut down, any settings not saved to the Storage Memory Card are lost. A backup should
be performed before the shutdown to ensure no data is lost. However, a backup should not be performed if
settings or data have recently been imported into the system, because performing a backup would overwrite
the imported data with the current PBX settings.
This screen can be accessed only in On-line mode.
1. Select the PBX site(s) to shut down in the Select Site drop-down menu.
2. Confirm the contents of the displayed warning message.
3. Click Backup or Skip according to the system’s status:
• Backup: Click to backup system settings. The system will prepare for shutdown after the backup has
been performed.
• Skip: The system is prepared for shutdown without performing a backup.
4. The STATUS LED on the front of the PBX will flash amber. When shutdown preparations are completed,
the STATUS LED will stop flashing and remain a solid amber. Once the STATUS LED stops flashing, you
may turn off the power switch on the back of the PBX.
88 PC Programming Manual Document Version 2016-03
5.5 System Control—System Shutdown
To Next Page
Loading...
