7.1 Utility—Diagnosis
7.1.1 Utility—Diagnosis—Card Diagnosis
Performs diagnostic tests on cards installed in the PBX, to identify the source of problems.
If any of the tests listed here returns the result "NG" ("No Good"), contact your dealer.
When
testing is complete, any cards that were set to OUS status must be returned to INS status if they are to
be used again.
This screen can be accessed only in On-line mode.
Card Test
Tests the relevant functions of a card to ensure that it is operating correctly. The tests carried out vary according
to the type of card being tested.
The tests that are performed on each card are listed below.
Note
Tests
marked with a "*" are available only for cards installed on a legacy gateway. For details, see 9.28 PBX
Configuration—[1-1] Configuration—Slot—Legacy-GW1/Legacy-GW2. For more information about
cards installed in legacy gateways, refer to the documentation of the legacy gateway PBX.
Test Type Available Cards
Local loop back diagnosis KX-NS1000 PBXs:
SLC2, LCOT2, PRI
Legacy Gateways:
DHLC, DLC, SLC8, SLC16
, MSLC16, ESLC16, EMSLC16,
CSLC16, MCSLC16, ECSLC24, MCSLC24, CSIF, LCOT8,
LCOT16, ELCOT, T1, PRI, OPB
Card CT Bus diagnosis* DHLC, DLC, SLC8, SLC16, MSLC16, EMSLC16, CSLC16,
ECSLC24, CSIF, LCOT, ELCOT, T1,
PRI, OPB
DTMF Receive test port KX-NS1000 PBXs:
SLC2
Legacy Gateways:
DHLC, SLC8, SLC16
, MSLC16, MCSLC16, ESLC16, EMSLC16,
CSLC16, ECSLC24, MCSLC24
PT loop back diagnosis* DHLC, DLC
DSP DTMF generator/receiver
diagnosis
*
T1
DSP DTMF receiver diagnosis* T1
Framer IC alarm signal detection
diagnosis
*
T1, PRI
Framer IC error detection diagnosis KX-NS1000 PBXs:
PRI
Legacy Gateways:
T1, PRI
114 PC Programming Manual Document Version 2016-03
7.1.1 Utility—Diagnosis—Card Diagnosis
To Next Page
Loading...
