Panasonic KX-NS1000 - Page 1075

Default
Disable
Value Range
Enable, Disable
Maintenance Console Location
24.4 UM Configuration
—[5-4] System Parameters—Parameters
Trunk Group (1–96)—Caller ID Callback
Specifies
whether or not the system allows a subscriber to call back the party who left a message in his or her
mailbox by using the caller ID information sent from the PBX. This setting applies to the CO line number used
when the message with Caller ID information was left in his or her mailbox.
Default
Enable
Value Range
Enable, Disable
Maintenance Console Location
24.4 UM Configuration—[5-4] System Parameters—Parameters
Trunk Group (1–96)—Outside
Line Access Sequence for Caller ID Callback (Up
to 16 digits / [0-9 * # D F R T , ; ])
Specifies the sequence of CO line access numbers for Caller ID Callback. This parameter is available when
the system executes Caller ID Callback without using EFA.
Default
9T
Value Range
Max. 16 digits consisting of 0–9,
, # and special codes
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
, : Dial Pause for 1 s (default)
; : Dial Pause for 3 s (default)
0–9, , #: Dial Code
Maintenance Console Location
24.4 UM Configuration
—[5-4] System Parameters—Parameters
Document Version 2016-03 PC Programming Manual 1075
24.4 UM Configuration—[5-4] System Parameters—Parameters