Panasonic KX-NS1000 - Page 290

NAT - Voice (RTP) UDP Port No.
Specifies the starting port number of the dynamic ports used for NAT Traversal.
Default
16000
Value Range
1024–65535
Maintenance Console Location
9.9 PBX Configuration—[1-1] Configuration
—Slot—V-SIPGW—Shelf Property
NAT - Keep Alive Packet Sending Ability
Specifies whether to send Keep Alive packets in order to maintain the NAT binding information. This setting
may be compulsory depending on the network conditions.
Default
Disable
Value Range
Disable, Enable
Maintenance Console Location
9.9 PBX Configuration—[1-1] Configuration
—Slot—V-SIPGW—Shelf Property
NAT - Keep Alive Packet Type
Specifies the type of Keep Alive packets to be sent out.
Default
Blank UDP
Value Range
Blank UDP, None
Maintenance Console Location
9.9 PBX Configuration—[1-1] Configuration
—Slot—V-SIPGW—Shelf Property
NAT - Keep Alive Packet Sending Interval
Specifies the interval time until the next Keep Alive packet is sent.
Note
This interval must be shorter than the NAT binding time of the router. The default value is appropriate in
most cases.
Default
20
290 PC Programming Manual Document Version 2016-03
9.9 PBX Configuration—[1-1] Configuration—Slot—V-SIPGW—Shelf Property