Panasonic KX-NS1000 - Page 942

Note
When "System" is selected, the Unified Messaging system uses the extension transfer sequence
pre-programmed in 24.4 UM Configuration—[5-4] System Parameters
—Parameters—PBX
Parameters—
PBX Environment—Extension
Transfer Sequence (Up to 16 digits / [0-9 * # D R F T
X , ;]).
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Mailbox Parameters
PC Programming Manual References
24.4 UM Configuration—[5-4] System Parameters—Parameters—PBX Parameters—
PBX
Environment—Extension Transfer Sequence
(Up to 16 digits / [0-9 * # D R F T X , ;])
Feature Manual References
20.1.15 Unified Messaging—Call Transfer Status
Call Transfer Sequence (Other)
Specifies the Call Transfer Sequence used by the mailbox. Only specified if Call Transfer Sequence
(Selection) is set to "Other".
Default
Not stored
Value Range
Enter a maximum of 16 characters consisting of 0
–9,
, # and special codes:
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
, : Dial Pause (default 1 s)
; : Dial Pause (default 3 s)
X: Extension Dialing
0–9, , #: Dial Code
Maintenance Console Location
20.1.2 UM Configuration
—[1-2] Mailbox Settings—Full Setting—Mailbox Parameters
Feature Manual References
20.1.15 Unified Messaging—Call Transfer Status
No Answer Time (Selection/Other)
Specifies
the length of time that the Unified Messaging system waits before handling unanswered calls to the
extension.
942 PC Programming Manual Document Version 2016-03
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting