IntelliCenter Control System User’s Guide
100 |
Setup Wizard [Advanced System Configuration]
REMOTES
iS10 Remote: To setup an iS10 remote, select Yes. If there is no iS10 remote
installed, select No and tap Next to continue.
• Remote Name: If needed, you can change the name of the remote.
• Enable Remote (ON/OFF): To enable the remote select ON. Tap Next to
continue.
• Remote Channel: Assign a channel from 1-4. Tap Return.
• Affected Pump: Select pump assigned to this remote.
• Button Assignments: Tap Configure. Tap Button 1, then tap the AUX circuit
button for this circuit. Tap Back and repeat for buttons 2-9. When all buttons
have been assigned, tap the Return arrow until SpaCommand remote screen is
displayed. Tap Next to continue.
SpaCommand
®
Remote: To setup a SpaCommand remote, select Yes. If there is no
SpaCommand remote installed, select No and tap Next to continue.
• Remote Name: If needed, you can change the name of the remote.
• Enable Remote (ON/OFF): To enable the remote select ON. Tap Next to
continue.
• Remote Channel: Assign a channel from 1-4. Tap Return.
• Affected Pump: Select pump assigned to this remote.
• Button Assignments: Tap Configure. Tap Button 1, then tap the AUX circuit
button for this circuit. Tap Back and repeat for buttons 2-9. When all buttons
have been assigned, tap the Return arrow until SpaCommand remote screen is
displayed. Tap Next to continue.
Chemical Controllers: IntelliChem
®
Controller and IntelliChlor
®
SCG
Note: The IntelliCenter
™
Control System supports one IntelliChem Controller
and one IntelliChlor
®
SCG.
IntelliChem Controller: Tap Yes then Next to configure one IntelliChem. Tap
No for no IntelliChem Controller installed. IntelliChem Settings: Select the
Channel (1-16) for the device.
Body 1 is assigned Pool/Spa for shared equipment or choose pool or spa for
single body systems, Body 2 is assigned to Spa for shared equipment systems.
This screen displays the body of water assigned to the device.
IntelliChlor SCG: Tap Yes then Next to configure one IntelliChlor SCG. Tap No
for no IntelliChlor SCG installed.
Body 1 is assigned Pool/Spa for shared equipment or choose pool or spa for
single body systems, Body 2 is assigned to Spa for shared equipment systems.
This screen displays the body of water assigned to the device.
Chlorination Output Levels: Pool /Spa Output Levels: Set the Pool and Spa
chlorine output levels. The system can only generate chlorine while the filter
pump is operating. Set the run time percentage to produce chlorine. The
higher the percentage the more chlorine is produced. Lower the percentage
for less chlorine production. Note: See page 78 for information about the
IntelliChem Controller and IntelliChlor SCG.
To Next Page
Loading...
Need help?
General
