Minimum Flow (GPM): This is the
minimum flow rate speed but still
generating sufficient flow in the pool.
The IntelliCenter™ Control System
will not run lower than 20 GPM. The
lower you can establish this flow rate
the better the energy savings.
+ Add Pump: To an IntelliFlo VSF pump, tap + Add Pump to access the pump
type screen and select IntelliFlo VSF.
Pump Type: To change the pump type
(function), tap Pump Type button to
access the pump type screen. Select
the pump for the list. Tap Check to
save the new pump type and return to
the previous screen.
Pump Name: Tap the Pump Name
button and enter the name of the
pump. Tap Check to save the name
and return to the previous screen.
Pump Address: Assign the pump
address from 1-16.
IntelliFlo VSF Settings: Pump Type, Name, Address, Min. Speed (450 RPM), Max.
Speed (3450 RPM), Min. Flow (GPM 20 GPM), Max. Flow (140 GPM), Step Size
(10-250 RPM), and Step Size (1-10 GPM). For information about priming the pump,
see page 70.
Maximum Flow (GPM): This is generally the flow rate required for backwashing the
pool filter. The pump will not allow a higher flow rate of 140 GPM to prevent damage
to the pool system hydraulics.
Step Size (RPM): The pump speed step size can be set from 10-250 RPM.
Step Size (GPM): The pump flow rate step size can be set from 1-10 GPM.
To Next Page
Loading...
Need help?
General
