8h 00m:9 00AM
Heat Source: Tap Heat Source and
select: Off, Heater, Solar, or Solar
Preferred. Heat Pump Only, Heat Pump
Preferred. To create a heat source
go to Settings > Advanced System
Configuration > Installation Setup
> Heaters, See page 72 for more
information.
Set Temperature: Tap the Plus or
Minus (+/-) button to set the Heat
Source set point temperature from
(40° F to 104° F).
Stop Time (Manual): Set the stop time
(am/pm) for the Weekly schedule.
Duration: Start time duration:
The equivalent time left after the start
time is established (e.g. 1:00 AM to 9:00
AM. The system clock calculates the
duration between the start and stop
time which is 8 hours. 24 Hrs. duration
is display when the Start/Stop time is
set to 8 AM to 8 PM. Note: To offset
Sunrise and Sunset start time, see
page 24.
Duration: Stop time duration: The
equivalent time left after the start time
is established (e.g. 1:00 AM to 9:00
AM. The system clock calculates the
duration between the start and stop
time which is 8 hours. 24 Hrs. duration
is display when the Start/Stop time is
set to 8 AM to 8 PM. Note: To offset
Sunrise and Sunset stop time, see
page 24.
Schedule - Weekly
Manual OP Priority (Default ON): If this feature is set to ON, a circuit can be
manually switched OFF and switched ON within a scheduled program and will
continue to run for a maximum of 12 hours or whatever that circuit Egg Timer is
set to, after which the scheduled program will resume if the schedule has not
ended before the Egg Timer has expired. See Settings > General page 44 for
more information.
To Next Page
Loading...
