Tap the Home screen Spa icon to display the Spa Pump control settings
screen. From this screen tap the Spa Pump button to activate the Spa heat source.
A Blue badge displayed on the Spa icon indicates the Pool/Spa pump button has
been manually turned on. The Blue badge displays until the pump button is turned
off. The badge displays the current pool water temperature. If there is a heat
source active, a flame icon is displayed with the pool water set point temperature
source. Note: For more information about screen badges, see page 3.
Spa
Spa Manual Heat ON/OFF: When set to
ON, overrides current heater settings
and schedules to allow manual control
of the spa heater settings (on/off and
temperature settings), see page 12.
Heat Mode Button: Tap the Heat Mode
button to select the spa heat source
type: Off (no heat source), Heater,
Solar Only, Solar Preferred, Heat Pump
(Heat Pump Preferred) or UltraTemp
®
(UltraTemp Preferred).
Note: To add a
heater, see page 72. To add a circuit
go to Settings > Advanced System
Configuration > Installation Setup >
Circuits, see page 56.
Select the heat mode from the Select
Heat Mode screen.
Spa Badge Icons: A Flame icon
indicates that the heat source has been
called for. A Snow Flake icon indicates
the UltraTemp (Hybrid) Heat Pump or
Solar Heat (if enabled) is in cooling
mode. A Sun icon indicates solar heat
is active. Select the heat source from
the Select Heat Source screen.
Note: The Spa button name can changed
(up to nine characters), go to
Settings
> Advanced System Configuration >
Installation Setup > Body Configuration, see
page 55.
Spa Pump On/Off Button: Tap this
button to turn the Spa Pump on to
activate the heater. Tap the Heat Mode
button to select a heat source.
Heating Set Point: Use the Up/Down
button to increase or decrease the heat
set point temperature.
To Next Page
Loading...
Need help?
General
