Pool/Spa
Add IntelliChlor and/or IntelliChem:
Tap Chemistry on the Home screen. Tap
Add Chemistry. Select one IntelliChlor
SCG and address up to four (4)
IntelliChem Controllers on the Select
Chemistry Device screen.
IntelliChlor SCG Settings: For dual
body systems, each device is assigned
to pool/spa. For single body systems,
select either Body 1 (pool), Body 2
(Spa).
Chlorination Output Levels: Set the
Pool and Spa chlorine output levels.
The system can only generate chlorine
while the filter pump is operating. Set
the percentage to produce chlorine.
The Spa outputs 1/20 of the pool output
when the Spa mode is switched on.
Note: If using the Filter Pump Relay
select Filter Pump Relay and Tap Next.
Choose either the Pool or Spa Relay and
can set the chlorination output levels
and turn Super Chlorination On/Off. Tap
the Back arrow to return to the previous
screen and Tap Next.
Super Chlorination (1 to 96 hrs.) (ON):
Tap the Start Super Chlorination button
to temporarily override the current
chlorination output levels with super
chlorination (100% output for the
selected time, typically 24 hours).
IntelliChem Settings:
Address (1-4): Select an address from
1-4 for the IntelliChem Controller.
Body Assignment: For dual body
systems, the device is assigned to pool/
spa. For single body systems, select
either Body 1 (pool), Body 2 (Spa).
From the Chemistry screen you can configure one IntelliChlor SCGs and one
IntelliChem Controller. Also see: Home screen(*): Tap Chemistry to access
IntelliChlor and IntelliChem operation summary screens, page 8.
To Next Page
Loading...
