IntelliCenter Control System User’s Guide
20 |
Weekly Program: This feature will automatically schedule a circuit or a
group of circuits to switch on and off at a specific start and stop time and day.
Circuits can be scheduled to turn On or Off all days, weekends, weekdays, or any
specific day of the week. Each 24 hour period, equipment (lights, heater, spa jets,
filter pump) can be programmed for multiple On/Off times. You can also schedule
which heat mode to use and also change the heat set point if necessary. The
Schedule screen lists each scheduled circuit(s) start and stop time, and days to
run.
Schedule - Weekly Program
Add a Program: From Home screen
tap Schedule > Add Schedule > Weekly
to add a new schedule.
Note: If the system is in Vacation
Schedule mode, the Home screen
Schedule icon will change to Vacation
text, see page 38.
Delete Program: Tap the Trash Can
icon and select the schedules to delete
from the list, then tap Check and the
Yes button to delete.
Weekly: Tap Weekly to display the
available AUX (auxiliary) circuit,
Feature circuits and Groups (circuits
and Feature circuits) as defined in the
Circuits screen, see page 56.
Circuits: Tap Circuit and select a circuit
from the assigned circuits list.
Note: Heat Source and Set
Temperature options only display for
Pool an Spa circuits. Use these options
to schedule your pool/spa heater to
heat the water at a specified time.
To assign circuits see Settings >
Advanced System Configuration >
Installation Setup > Circuits and
Feature Circuits, see page 56.
Everyday: Tap Everyday and select the
days of the week (Mon-Sun), Weekdays,
Weekends, Every Day, or No Days to
run the schedule. Tap Check to save
and return to the previous screen.
To Next Page
Loading...
Need help?
General
