Pentair INTELLICENTER User Manual

IntelliCenter Control System User’s Guide
| 37
Service Mode
Select High Speed Circuits
Enabling Service Mode will disable all circuits that are
currently acve.
Auto Service Timer
Service Mode
Enabling Service Mode will disable all circuits that are
currently acve.
Auto Service Timer
Manual Circuit Control
Service Mode
Enabling Service Mode will disable all circuits that are
currently acve.
Auto
Manual Circuit Control
Service Timer
Time Out (hours)
2
Remaining Time 02 Hr 56 Min 50 Sec
Manual Circuit Control
AUX2 AUX3
AUX4
AUX5
Spa Light Pool Light
IntelliBrite MagicBowl
GloBrite Landscape Lights
Pool Spa Features Lights
Air Temp 65° F
Schedule Usage Chemistry Status
3 3
84°
78°
92°
85°
8:00 A.M.
SERVICE MODE
Service Mode: Service and Timer mode
is used for pool/spa maintenance or
service purposes to manually control
and test system equipment. During
Service mode, the Outdoor Panel,
Indoor Control Panel and Wireless
Remote Home screen will display
SERVICE MODE. All system auxiliary
circuits will be disabled once Service
or Timer is selected. When AUTO is
selected, normal operation will resume
and the system will not be in service
mode.
Note: If the panel is passcode
protected, enter the four digit
assigned passcode, see page 45 for
details.
Auto: When Auto is selected it
indicates that the system is operating
normally and not in Service or Timer
mode.
Service: When Service is selected,
all system auxiliary circuits will turn
OFF. To enable auxiliary circuits select
Manual Circuit Control and choose the
system auxiliary circuits to turn on/off.
Manual Circuit Control: Choose the
auxiliary circuits to allow manual
control for shared equipment or dual
equipment). Tap the circuit name
to turn the circuit on/off. Note: For
shared equipment, only one valve can
be activated at a time.
Timer: Use the Timer mode to leave
the system in service mode up to 24
hours and automatically return to Auto
mode (normal system operation) after
the maximum hours set has elapsed.
Set the count-down timer from 1 to 24
hours for selected circuits to remain in
service mode.
Tap Manual Circuit Control and choose
the circuits to enable. Note: Circuits
selected in the Service Manual Circuit
Control screen are retained in the Timer
Manual Circuit Control screen.

Pentair INTELLICENTER Specifications

General

Expandable	Yes
Energy Management	Yes
Touchscreen Display	Yes
Remote Access	Yes, via Mobile App
User Interface	Touchscreen
Remote Monitoring	Yes
Number of Circuits	Up to 40
Wireless Connectivity	Yes
Power Requirements	120V AC
Enclosure Rating	NEMA 3R