Pentair INTELLICENTER - Page 73

IntelliCenter Control System User’s Guide
| 65
Pump Status
OK - No Problems Detected
Pump appears to be running normally. Click
here to view possible issues not being detected.
100
RPM
750
AUX3Circuit
Speed (RPM)
1000
Affiliated Circuit Sengs
Circuits (1-8)
1000 RPM
Add Circuit
Pool
Booster Pump
WF Pump
2500 RPM
1340 RPM
Pumps (IntelliFlo
®
VS)
Speed Circuits: Assign the
speeds to the circuits you wish to use.
Tap Speed Circuits and tap Add Circuits
to assign a new AUX circuit. To change
the pump speed of a listed circuits, tap
the AUX name to change the assigned
RPM setting. Tap Return to save the
setting and return to the previous
screen.
Affiliated Circuit Settings:
Circuit: The assign circuit to control
the pump speed.
Speed (RPM): Assign pump speed from
450 to 3450 for the selected circuit.
Pump Status: Shows the current
power usage in Watts, speed, in
revolutions per minute (RPM) while
the pump is operating. Tap Return to
return to the previous screen. Also
see: Tap Status on the Home screen to
display the current pump status and
error condition.