Embroidery Edit
Smart Toolbox on a Design
The Smart Toolbox is available in the sewing and
embroidery area. Touch & hold anywhere in your work
area to open the Smart Toolbox and select the option
you want.
The options included in the Smart Toolbox differs
depending on where it is used. Examples of options are
Duplicate, Mirroring and Delete.
Duplicate
Select Duplicate to make a copy of the selected design(s).
Multi Duplicate
Select Multi Duplicate to open a keypad where you can
enter desired number of copies of the selected design(s).
Mirroring
To mirror a design sideways, select Mirror Side to Side.
To mirror a design lengthwise, select the Mirror End to
End
Move into Hoop
A red frame will surround the embroidery area if a
design is placed outside the hoop area. Select Move Into
Hoop to move any design that is outside the hoop area
into the hoop area. The design will be placed at the
outermost edge of the hoop.
Grid On/Off
Select if you want to have a grid in the hoop area.
Delete/Delete All
Select Delete, and the selected design(s) will be deleted
from the embroidery area. If more than one design is
selected, a pop-up message will appear. Touch OK to
confirm to delete selected designs.
Select Delete All to delete all loaded designs from the
embroidery area. Touch OK in the pop-up message to
confirm.
Read about Embroidery Edit
Select to open the User’s Guide and read more about
Embroidery Edit.
Reset Toolbar
Select if you want to reset your Toolbar to default.
Read about customizing your work area.
123
To Next Page
Loading...
Need help?
General
