Sewing
Stitch Density
The stitch density control adjusts the density (the
distance between the individual satin stitches that make
the entire stitch). The density does not affect the actual
length of the entire stitch.
Touch – to increase the density. Touch + to decrease the
density. The number above the control shows the
distance between satin stitches in mm.
Tip: Decrease the density to get different visual effects e.g.
when using speciality threads.
Mirroring
1. Mirror Side to Side
2. Mirror End to End
To mirror a stitch or stitch sequence sideways, touch
Mirror Side to Side. To mirror a stitch or stitch sequence
lengthwise, touch Mirror End to End.
Tip: Use the Smart Toolbox to open a shortcut for mirroring.
Note: Some stitches e.g. buttonholes cannot be mirrored.
Buttonhole Slit Length
Set the buttonhole slit length by using - to decrease and
+ to increase when sewing a buttonhole with the
Sensormatic Buttonhole Foot.
You can also sew a manual buttonhole, read about how
to sew a manual buttonhole and how to repeat a manual
buttonhole in the Sewing Techniques chapter.
Button Stitch Repetition
When sewing a button, you can set the number of stitch
repeats. Touch the – or + in the control to decrease or
increase the number of stitch repeats.
90
To Next Page
Loading...
Need help?
General
